Harbor Freight Tools 65761 Manual de usuario descargar pdf (Pagina 16)

SKU 65761 For technical questions, please call 1-800-444-3353. Page 16

Air Filter Element Maintenance

Wipe off the air cleaner cover.1.

The air cleaner cover is held in place 2.

by a wing nut or clamps. Remove it.

Remove the air lter element.3.

Cleaning:4.

For “paper” lter elements: a.

To prevent injury from dust and

debris, wear ANSI-approved safety

goggles, NIOSH-approved dust

mask/respirator, and heavy-duty

work gloves. In a well-ventilated

area away from bystanders, use

pressurized air to blow dust out

of the air lter from the side oppo-

site the lter’s normal air ow (the

“clean” side of the lter).

If this does not get the lter reason-

ably clean, replace it.

For foam lter elements: b.

Wash the element in warm water

and mild detergent several times.

Rinse. Squeeze out excess water

and allow it to dry completely. Soak

the lter in lightweight oil briey, then

squeeze out the excess oil.

Install the new lter or the cleaned 5.

lter. Secure the Air Cleaner Cover

before use.

Spark Plug Maintenance

Disconnect spark plug wire from 1.

end of plug. Clean out debris from

around spark plug.

Using a spark plug wrench, remove 2.

the spark plug.

Inspect the spark plug: 3.

If the electrode is oily, clean it using a

clean, dry rag.

If the electrode has deposits on it,

polish it using emery paper.

If the white insulator is cracked or

chipped, the spark plug needs to be

replaced.

When installing a new spark plug, ad-4.

just the plug’s gap to the specication

on the Technical specication chart.

Do not pry against the electrode or

the insulator, the spark plug can be

damaged.

Install the new spark plug or the 5.

cleaned spark plug into the engine.

Gasket-style: Finger-tighten until the

gasket contacts the cylinder head,

then about 1/2-2/3 turn more.

Non-gasket-style: Finger-tighten until

the plug contacts the head, then

about 1/16 turn more.

Apply dielectric spark plug boot 6.

protector (not included) to the end of

the spark plug and reattach the wire

securely.

Fuel Filter Replacement (if equipped)

WARNING! TO PREVENT

SERIOUS INJURY FROM

FIRE:

Replace the fuel lter in a

well-ventilated area away from igni-

tion sources. Do not smoke.

Wait for engine to cool completely 1.

before proceeding.

Wear protective gear including, ANSI-2.

approved safety goggles, NIOSH-

approved dust mask/respirator, and

nitrile gloves.

Wipe gas rell cap and surrounding 3.

area. Remove gas rell cap.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 36 37

Comentarios a estos manuales

Sin comentarios