Harbor Freight Tools OBD II & CAN Professional Scan Tool Manual descargar pdf (Pagina 21)

Page 21For technical questions, please call 1-888-866-5797.Item 62120

Erase Codes

Mode $04 Clear/Reset Emission-Related Diagnostic Information

WARNING! Do not clear any DTCs before

the vehicle has been repaired and the

system has been checked completely by

a qualified technician.

As long as there is a fault

condition, the DTCs will continue

to set and turn on the MIL.

Note: If the vehicle stores permanent

DTCs, they cannot be erased by the

Scan Tool. They can only be erased

by the OBD II system, after repairs are

made, and a set number of Driving

Cycles have been completed.

1. Turn the vehicle’s ignition ON

with the engine OFF.

2. From Diagnostic Menu, select

Erase Codes, then press OK.

Diagnostic Menu 2/11

Read Codes

Live Data

View Freeze Frame

I/M Readiness

02 Monitor Test

On-Board Mon. Test

Erase Codes

Figure Y

3. Choose whether or not to erase codes.

Erase Codes

Erase trouble codes!

Are you sure?

YES NO

Figure Z

4. When DTCs have been erased, the

following message will appear.

Figure 5.9

Erase Codes

Erase Done!

Press any key to con.

Figure AA

Note: Erasing codes will reset the Monitors

to incomplete status. A Drive Cycle will

need to be completed before performing

an Emissions Readiness Test.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Comentarios a estos manuales

Sin comentarios

Harbor Freight Tools OBD II & CAN Professional Scan Tool Manual Pagina 21

Comentarios a estos manuales