Harbor Freight Tools 3/8 in. Variable Speed Reversible Drill Manual descargar pdf (Pagina 10)

Page 10 For technical questions, please call 1-888-866-5797. Item 60614

SAFETY OPERATION MAINTENANCESETUP

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this

manual including all text under subheadings therein before set up or use of this product.

Tool Set Up

TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:

Make sure that the Trigger is in the off-position and unplug the tool from its

electrical outlet before performing any procedure in this section.

Drill Bit Installation

CAUTION! Wear heavy-duty work gloves to provide

protection when inserting and removing drill bits.

Drill bits become very hot during use.

Do not remove drill bits until the bit has cooled.

1. While holding the ring behind the collar of the

Chuck with one hand, rotate the collar of the

Chuck counterclockwise until the jaws of the

drill are opened enough to fit the drill bit.

2. Place the desired drill bit into the drill

between the Chuck Jaws.

3. Hand tighten the Chuck until the bit is held securely

in place, centered between the Chuck Jaws.

NOTICE: Use sharp bits. Dull, bent, or damaged

bits will cause stress on the drill and/or break.

Workpiece and Work Area Set Up

1. Designate a work area that is clean and well-lit.

The work area must not allow access by children

or pets to prevent distraction and injury.

2. Route the power cord along a safe route to reach

the work area without creating a tripping hazard or

exposing the power cord to possible damage. The

power cord must reach the work area with enough

extra length to allow free movement while working.

3. Secure loose workpieces using a vise or clamps

(not included) to prevent movement while working.

4. There must not be objects, such as utility lines,

nearby that will present a hazard while working.

General Operating Instructions

1. Make sure that the Trigger is in the

off-position, then plug in the tool.

2. Use the Forward/Reverse Switch above the Trigger

to determine the rotation direction of the Chuck. Slide

it to the right side for reverse Chuck rotation. Slide to

the left side for forward Chuck rotation. See Figure A.

3. CAUTION! Allow chuck to come to complete

stop prior to changing its direction of rotation.

4. Squeeze the Trigger to start the tool. The Trigger

has a variable speed feature. Pressing it lightly

will make the tool operate slowly; pressing

more will cause the tool to operate faster.

5. To lock the Trigger in the ON position, squeeze

the Trigger, press in the Lock ON button, and then

release the Trigger. The tool will operate continuously.

To stop the tool, squeeze and release the Trigger.

6. To prevent accidents, turn off the tool and

disconnect from power source after use. Clean,

then store the tool indoors out of children’s reach.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Harbor Freight Tools 3/8 in. Variable Speed Reversible Drill Manual Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas Harbor Freight Tools 3/8 in. Variable Speed Reversible Drill