Harbor Freight Tools Manual Tire Changer Manual descargar pdf (Pagina 6)

Page 6 For technical questions, please call 1-888-866-5797. Item 62317

5. Lift Bead Breaker Handle up and

slide tire around so that Bead

Breaker Shoe can be set against

the opposite end of rim.

6. Set the Bead Breaker Shoe against

the edge of tire rim. Push down

on Bead Breaker Handle, allowing

the Bead Breaker Shoe to lift other

end of tire bead off of rim.

7. Lift Bead Breaker Handle up,

flip tire over and reposition

tire against mounting tab.

8. Set Bead Breaker Shoe against the

edge of tire rim and push down on

Bead Breaker Handle, removing bead

from rim. See Figure I, below.

Figure I

9. Raise Bead Breaker Show and slide tire

around. Push down on Bead Breaker

Handle, removing bead from rim.

10. Lift Bead Handle up and remove

tire from Post Base.

11. Remove Post Cap (2) and Spider

Post (4) from top of Center Post.

12. Set tire onto the Center Post.

NOTE: Make sure tire’s valve stem is

facing up and Lug Pin (3) is sticking

up through lug hole of rim.

13. Thread Spider Post over Center

Post with tapered side going into

wheel hub. See Figure J, below.

14. Thread Post Cap onto Center Post.

This will tighten Spider Post, locking

tire into place. See Figure J, below.

Figure J

15. To tighten Post Cap, place flat end

of Mount/Demount Bar through top

of Post Cap and pull on Mount/

Demount Bar. See Figure K, below.

Figure K

16. Remove Mount/Demount Bar from Post

Cap and set end against bead. Push

down on Bar, forcing bead away from

rim.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Harbor Freight Tools Manual Tire Changer Manual Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para No Harbor Freight Tools Manual Tire Changer