Harbor Freight Tools xenon Advance Timing Light Manual descargar pdf (Pagina 5)

Page 5For technical questions, please call 1-800-444-3353.Item 40963

Operating Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the

beginning of this document including all text under subheadings therein

before set up or use of this product.

Note: These general instructions will

not apply to all engine designs and/

or vehicles. Consult your engine

manufacturer’s service instructions

which supersede these instructions.

1. Locate the engine’s timing mark

by referring to the vehicle’s

engine manual or contacting the

manufacturer. Refer to the vehicle’s

manual or contact the manufacturer

for the timing specications of

the engine being tested.

2. Start the engine and run for 5-15

minutes until normal operating

temperature is reached.

3. Stop engine.

4. Turn the Timing Advance Knob on

the back of the timing light to 0°.

5. If the vehicle specications and

instructions require it, locate the

vacuum line that attaches to

the ignition distributor vacuum

advance and disconnect the

line and plug the end of it.

A golf tee or small pencil may

be used to plug the line.

Note: The Spark Plug Clamp is fragile and

may break if dropped or struck sharply.

6. Connect the timing light to the 12 V

Battery, and connect the Spark Plug

Clamp to the Spark Plug Wire as shown.

The spark plug clamp must be

connected with the arrow on the clamp

pointing towards the spark plug.

Figure 2

Timing Light Hook Up

Spark Plug

Clamp

#1 Spark

Plug

7. Start the engine and

operate at idle speed.

WARNING! Be careful working around a

running engine. Moving belts and fans

can cause severe injury if contacted.

Metal engine parts are very hot.

Do not contact any part of the engine.

8. Squeeze the trigger on the timing light

and direct the ash onto the engine

timing marks to obtain a reading.

Compare the reading from the

timing mark to the reading in the

manufacturer’s specications.

If the timing does not match with the

timing listed in the manufacturer’s

specications, adjust the timing.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Harbor Freight Tools xenon Advance Timing Light Manual Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Eléctricas Harbor Freight Tools xenon Advance Timing Light