Harbor Freight Tools Variable Speed Multifunction Air Tool Manual descargar pdf (Pagina 9)

Page 9For technical questions, please call 1-800-444-3353.SKU 67538

Note: Residual air pressure should not be

present after the tool is disconnected

from the air supply. However, it is a

good safety measure to attempt to

discharge the tool in a safe fashion

after disconnecting to ensure that the

tool is unpowered.

INSTRUCTIONS FOR

PUTTING INTO USE

Read the ENTIRE IMPORTANT

SAFETY INFORMATION

section at the beginning of this

manual including all text under

subheadings therein before set

up or use of this product.

Inspect tool before use, looking

for damaged, loose or missing

parts. If any problems are

found, do not use tool until

repaired.

Components & Controls

Figure 1

Sandpaper (46)

3” Triangular

Sanding Pad (45)

Trigger

Lever

(41)

Safety Catch (38)

Hex

Wrench

(43)

Air Inlet

Tool Set Up

TO PREVENT

SERIOUS INJURY

FROM ACCIDENTAL

OPERATION:

Turn the tool off, detach the

air supply, safely discharge

any residual air pressure in

the tool, and release the

throttle and/or turn the switch

to its off position before

assembling or making any

adjustments to the tool.

Note: For additional information regarding

the parts listed in the following pages,

refer to the Assembly Diagram near

the end of this manual.

Work Piece and Work Area Set Up

Designate a work area that is clean 1.

and well-lit. The work area must not

allow access by children or pets to

prevent distraction and injury.

Route the air hose along a safe 2.

path to reach the work area without

creating a tripping hazard or exposing

the power cord to possible damage.

The power cord must reach the work

area with enough extra length to

allow free movement while working.

There must not be hazardous 3.

objects, such as utility lines or foreign

objects, nearby that will present a

hazard while working.

You must use personal safety 4.

equipment including, but not limited

to, ANSI-approved eye and hearing

protection, as well as heavy work

gloves.

Before beginning work, provide for 5.

sparks and debris that will y off the

work surface.

Remove the Plug (28) from the Air 6.

Inlet and thread the Coupler Plug

(44) onto the tool, using three to four

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios